Note Cisco Aironet 340 and 350 Series Access Points and 1200 series access points that currently run firmware version 12.01T or earlier do not support IOS. Do not attempt to load an IOS image on an access point that does not run IOS.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...