Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

AP1220 not broadcasting networks

Hi,

I have an AP1220 configured connected to trunk port on a 2980 switch. On the AP i have it setup like this on the Dot1Radio0 Interface:

interface Dot11Radio0

no ip address

no ip route-cache

!

ssid Internal

vlan 7

authentication open

guest-mode

!

But the SSID is not getting broadcasted out. I have the same setup on another AP in another office and its working fine. Any ideas why it is not broadcasting my network? could it be faulty?

Thanks,

rob.

1 REPLY
Bronze

Re: AP1220 not broadcasting networks

go into the AP GUI and enable Broadcast SSID checkbox in the corresponding page and click Apply. Restart and see if the problem still persists.

140
Views
0
Helpful
1
Replies