AP1242AG: Telnet and http accesses:

[martec_acbarcelo]

Hi,

I can not telnet the AP1242 and I can not use its web GUI. I do not find the commands to enable Telnet and HTTP (such as "config network telnet / webmode" of the WLC2006). Does anybody provide them.

AP1242 releases are:

* Cisco IOS Software, C1240 Software (C1240-K9W8-M), Version 12.3(11)JA1, RELEASE)

* BOOTLDR: C1240 Boot Loader (C1240-BOOT-M) Version 12.3(7)JA1, RELEASE SOFTWARE )

* LWAPP image version 4.0.206.0

Thanks by advance. Best Regards,

Alain-Claude

[Paul Webster]

Hi, i belive there is a mistake, since the LWAPP only should work with a wireless lan controller.

http://www.cisco.com/en/US/products/ps6521/products_data_sheet0900aecd8031c968.html

When the LWAPP turns on it locates the WLC by an arp request, and the controller set's up all the configuration on the AP. You can not configure a LWAPP true TELNET or HTTP.

If you only need an AP you should practice a downgrade on your AP to make it work as an autonomous AP.

http://www.cisco.com/en/US/products/hw/wireless/ps430/prod_technical_reference09186a00804fc3dc.html#wp161272

Check it Here.......

Hope it helps!!!!

[martec_acbarcelo]

Hi Paul,

I understood that the lightweight AP is monitored by a WLC (I use a WLC2006). I am setting up a test-bed and I intended to use telnet and / or http to display traces and check configuration directly from the AP without connection to the console port. I will do it (at least for the configuration) through the WLC.

Thanks for your answer.

Best Regards,

Alain-Claude