Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. And see here for current known issues.
In our WLAN setup we have two 350 AP's configured in bridge - client mode i.e. one 350 seies AP is getting feed from 350 AP(acting as a bridge).
Now, I am planning to replace the Bridge mode AP from 350 to 1252 LWAP.means 350 will take feed from 1252 AP.
I would like to know whether this solution is feasible using 1252 series APs acting in bridge mode ? If yes, then what are the steps to be followed to achieve the same.