Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

AP1602E - basic configuration guide ..

Hi

I bought a new  1602E ap  .. so it comes with no documentation and the only doc that i foudn in the net  it was this:

http://www.sws.cz/prod_img/cisco/ap1600getstart.pdf

but  I need the  started guide to the basic configuration ..

My concern is  because   the AP will be used for a  producction enviroment and    the  point will  be

what will be the  best  radio configuration  with  open with non security  .. ? 2.4 or 5ghz ..

is any one know about it  I appretitate your support

thnks  in advanced

regards

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

AP1602E - basic configuration guide ..

Hi,

do you have AIR-CAP or AIR-SAP
as AIR-CAP is controller based AP where you need the WLC to get the AP configured. Simply you have to connect the AP with POE.

AIR-SAP is standalone and below is the doc to configure it:-

http://www.cisco.com/en/US/docs/wireless/access_point/15_2_4_JA/configuration/guide/scg15.2.4_book.html

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a0080c0b93c.shtml


2.4 GHZ or 5GHZ depends on what type of clients you want to connect ? If you have clients with A radio/ N radio then you need 5 GHZ and if your client is having G radio/N radio you can go for 2.4 GHZ.

2 REPLIES
Cisco Employee

AP1602E - basic configuration guide ..

Hi,

do you have AIR-CAP or AIR-SAP
as AIR-CAP is controller based AP where you need the WLC to get the AP configured. Simply you have to connect the AP with POE.

AIR-SAP is standalone and below is the doc to configure it:-

http://www.cisco.com/en/US/docs/wireless/access_point/15_2_4_JA/configuration/guide/scg15.2.4_book.html

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a0080c0b93c.shtml


2.4 GHZ or 5GHZ depends on what type of clients you want to connect ? If you have clients with A radio/ N radio then you need 5 GHZ and if your client is having G radio/N radio you can go for 2.4 GHZ.

AP1602E - basic configuration guide ..

thanks it is 

AIR-SAP

I will chek the documents  ..  thnks  //

534
Views
0
Helpful
2
Replies