AP702W - Has anyone been able to get the LAN Data port to work on the AP702W?
Able to get voice working on the 702W but now would like to use port 1 as a data port. I have been no been able to connect via data. the AP702 is connected via 2960S access port. If you have been able to get the data port working on the AP702 can you please share your configuration ?
For now, (until more control is added in the software) all the LAN ports are locally switched and mapped to the 702W VLAN, and do not appear on the Wireless LAN Controller or AP.
Initially, the ports are disabled and may be enabled manually via the CLI.
This was done to minimize any security risks. Here are the CLI commands to enable the ports.
(Cisco Controller)> config ap lan <port id> <enable/disable> <AP-NAME>
(Cisco Controller)> show ap lan <port id> <AP-NAME>
(Cisco Controller)> show ap lan port-summary <AP-NAME>
Due to the early release of the 126.96.36.199 code, the enable/disable all command was not integrated, so you must configure each AP and each port, one by one. With code 8.0 and later, a more refined control along with VLAN support is being added to these ports.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...