Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

as that mode is an AP

Hello,

How can i know if un AP1240AG this in mode autonomous or mode lightweight????

2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Super Gold

Re: as that mode is an AP

1.  Look at the logs for any sign of the word "JOIN".  If this is visible, then you are running one of the two LWAP images;
2.  Look at the file being used.  If the filename has "rcv" then you are using the LWAP recovery image.
3.  If you are running an LWAP image (full or "rcv") you will NOT be able to save your config.

Cisco Employee

Re: as that mode is an AP

The methods Leo has mentioned are good ones. Another easy way is to look at the image name in a 'show version' output. If the image name contains:

1) k9w7 - it is autonomous

2) k9w8 - it is lightweight

-Matt

3 REPLIES
Hall of Fame Super Gold

Re: as that mode is an AP

1.  Look at the logs for any sign of the word "JOIN".  If this is visible, then you are running one of the two LWAP images;
2.  Look at the file being used.  If the filename has "rcv" then you are using the LWAP recovery image.
3.  If you are running an LWAP image (full or "rcv") you will NOT be able to save your config.

Cisco Employee

Re: as that mode is an AP

The methods Leo has mentioned are good ones. Another easy way is to look at the image name in a 'show version' output. If the image name contains:

1) k9w7 - it is autonomous

2) k9w8 - it is lightweight

-Matt

Community Member

Re: as that mode is an AP

Thanks a lot, was very useful

266
Views
5
Helpful
3
Replies
CreatePlease to create content