Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Assigning physical port to a specific vlan

  I'm hoping I missed somethign small here. I created a wlan just for our wireless IP phones.  I assigned an interface I created which in turn was set to a specific port on company 2504 WLC.  Connecting switchport is set to trunk. Right now I can't ping the voice wlan interface.

Any suggestions would be greatly appreciated

Thanks!!!

1 REPLY
Hall of Fame Super Silver

Assigning physical port to a specific vlan

On the trunk port, make sure you only allow the voice vlan and on the other ports, make sure you only allow the vlans that you are allowing to use on those ports.  So if port 1 is for management, port 2 is for wireless data and port 3 is for wireless voice.  You only allow the management vlan for the trunk port on port 1, wireless data vlan for port 2 and wireless voice for port 3.

-Scott
*** Please rate helpful posts ***
238
Views
0
Helpful
1
Replies
CreatePlease login to create content