Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

auto-assignment of ports to etherchannel in a WISM module fails

I'm running 12.2(18)SXF11 on a cat6509 with two WiSM module; one module is fine (after many reloads...) but the 4 Gib-ports of the 2nd controller are not assigned to the auto created Portchannel (Po290)

Any manual intervention is denied.

What to do here?

2 REPLIES
Hall of Fame Super Silver

Re: auto-assignment of ports to etherchannel in a WISM module fa

You can always create a new portchannel and assign that WiSM to it. You just won't be able to delete the auto created portchannel. I never use the auto created portchannel... but that is just me.

-Scott
*** Please rate helpful posts ***
Community Member

Re: auto-assignment of ports to etherchannel in a WISM module fa

I went back to 122-18.SXF8 and 4.2.112.0.

Now everything works as promised.

-> Be aware of newest versions...

173
Views
0
Helpful
2
Replies
CreatePlease to create content