I have loaded k9w7 & k9w8 images into the flash of 1552H outdoor accesspoint from ap: mode using "tar -xtract tftp:" back to back.
Now my requirement is, whenever i want to switch to lwap or standalone mode, i just go to ap: mode and set boot as k9w7/k9w8 image and boot.
So that it will boot as lwap mode or standalone mode without the need of transferring again into the flash.
Here i uploaded both the images into flash and first booted with lwap image(k9w8). Then i wanted to boot with standalone image(k9w7). so i went to ap: mode and typed boot flash:/<dir name>/<file of k9w7>.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...