I agree with Leo. If you see a dramatic drop in signal and an increase in noise from when you performed a survey, what was the difference from then and now? Was this new construction? How long ago was it surveyed?
The site survey was performed with the business operational so everyone working and present.
The WLC and accesspoint was installed and tested while the building was empty.
The install was at an existing customer site so not a new build.
The original survey was performed a month prior.
Something to bare in mind though is the fact that the original AP1041N that is used for testing/confirming site survey results was used again along side the installed LAP1041N to confirm original site survey results.
The AP1041N produced the same results as the original day the site survey was performed.
Okay that makes it clear. I have never surveyed with the 1040's so I really can't comment. When I have surveyed with the other APs (1130, 1242, 1252, 1142, 1260, 3500) my results have been close to the lwapp/capwap implementation. Did you set the TX power on the autonomous 1040? Can you post the ios configuration so we can see how it was configured.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...