Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Bandwidth Management using 5508

I setup a WLC5508 with 2 SSIDs, one for guest traffic and another for internal users.  They are in separate subnets and are routed out to the internet via 2 different isps, with the guest network going over a bonded t1 and the internal users going out the primary internet connection for the company.  While this works as desired and we've verified that while on the guest network we're going out the right isp, we've encountered an issue with saturation of the bonded t1 pipe by guests.  We'd like to find a way to limit a guest to a capped down/up stream if possible, with downstream being the most important.  The infrastructure includes 3560 switches and AIR-CAP3502I-A-K9 access points. 

Everyone's tags (3)
1 REPLY

Re: Bandwidth Management using 5508

You can do bandwidth limiting on the WLC but currently it is only downstream from the WLC.

What you'll want to do is enable rate limiting from the edge in on the guest subnet. This will give you the greatest control of your bandwidth on the network

Steve

Sent from Cisco Technical Support iPhone App

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
499
Views
0
Helpful
1
Replies
CreatePlease login to create content