Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Best way to upgrade antonomous APs

Is anyone have a best way to upgrade a group of 1230 and 1231 antonomous APs.

They all don't have enough space for new code, which mean old code have to delete. Most the time they are not same code. I wonder if there is any software that we can add these APs to a list and push it out.

Thanks,

4 REPLIES
Silver

Re: Best way to upgrade antonomous APs

Use the Cisco Upgrade Tool, which can be downloaded in the wireless downloads section. It automatically upgrades your APs and does a pretty quality job at it, too.

It can be a bit cumbersome with large numbers of APs, but it gets the job done.

New Member

Re: Best way to upgrade antonomous APs

You can either use the upgrade tool available on CCO downloads under wireless. Or use WCS. We just used WCS and upgraded 90 1231 AP's it went very well.

New Member

Re: Best way to upgrade antonomous APs

We want to upgrade the IOS without converting to LWAPP.

Thanks,

Hall of Fame Super Gold

Re: Best way to upgrade antonomous APs

I just type the command in Notepad and cut-n-paste it. Here's what I've done:

conf t

no boot sys

end

wr

delete /f /r flash:

arch tar /x tftp:/// flash:

reload at

Yabba-da, yabba-da, that's all folks!

162
Views
0
Helpful
4
Replies