Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Bootp and Access Point 1231G

Dear all,

Is it possible to load a config-file from a bootp-server to an access-point?

Which commands will I need on the cli?

THX for the answers ;-)

Kind regards,

Ingo

1 REPLY
Silver

Re: Bootp and Access Point 1231G

Click Read Config File From Server. The management system checks the server for several possible configuration filenames while attempting to load the configuration file. If the management system doesn't find the first filename, it continues to the next until it finds the file and loads it. It checks the server for the following names in the following order:

a. [system name].ini

b. [IP address].ini

c. [boot file from DHCP/BOOTP server].ini

d. [boot file from DHCP/BOOTP server].ini by TFTP

141
Views
0
Helpful
1
Replies
CreatePlease login to create content