Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Bridge 350 Association Prob,

am connecting to sites via a 350 bridge link. One is set to root and the other is set to non root without clients. The root bridge assoction light is on constant but on the non root bridge the association light is lit for 2 thirds of a second but then blinks. However i am able to ping devices either on either network.

I have set these up before as bridge links and both association lights normally stay solid. I have no wep configured and also i have set the 'loss of backbone' in ethernet harware to 'no action' instead of 'switch to repeater mode'. I am running 12.02T1 which I understand to be the latest software.

Just wondering if anyone could help, or the units working correctly. Thanks

2 REPLIES
Cisco Employee

Re: Bridge 350 Association Prob,

Are you sure it is not associating and reassociating ? Look in the logs of both of them.

What signal strength and quality do you see on the antenna alignment test ?

New Member

Re: Bridge 350 Association Prob,

According to the units are associating correctly. From the root bridge in the associations I can see both units and also from the non root bridge I can see both associations. The units are being tested about 20ft apart and the alignment test shows 100% strength and 100% quality,

151
Views
0
Helpful
2
Replies