Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Bridge authentication using EAP

Hi all,

I'm trying to connect two buildings using a point-to-point wireless connection. I'm not having any luck getting a non-root BR1310 to connect to a root BR1310 using open authentication with EAP. My non-root bridge keeps throwing up the error: Interface Dot11Radio0, cannot associate: EAP authenticating.

I have the setup currnetly working using LEAP to the Root's RADIUS server. However, I'd really prefer the RADIUS authentcation use my corporate IAS server which doesn't support LEAP.

Any suggestions?

Thanks!

1 REPLY
New Member

Re: Bridge authentication using EAP

I talked to TAC and found out that the non-root BR1310 supports authentication as a client only using LEAP. So, I'm back to using the built-in RADIUS server instead of my corporate one.

1203
Views
0
Helpful
1
Replies