I have tried to bridge two wired LAN with two AP340. I have setup bridge A as ACCESS POINT ROOT and IP address as 192.168.1.59 and the brige B as CLIENT NON ROOT and IP address 192.168.1.49 (I have also tried with different network and as REPEATER NON ROOT for bridge B) all seems ok, but bridge B has the forwarding state of the ethernet always set as BLOKING and there is no way to change the status. Where am I wrong ? Is possible this kind of configuration ? Can I use also on AP340 yaghi antennas ?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...