Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Brocade FCX PoE with Cisco LAP

Hi,

We are using Brocade FCX PoE switches with AIR-LAP1142N-N-K9 and AIR-LAP1252AG-A-K9. We have some issues that may or may not be due to the Brocade-LAP links but would like a reality check with other Brocade sites. If you are successfully using Brocade PoE switches with Cisco LAPs can you give a typical port config?

Example configs we have have tried:

interface ethernet 1/1/2
no cdp enable
inline power power

!
interface ethernet 2/1/23
port-name TX_LWAP01
no fdp enable
no cdp enable
inline power power-by-class 4"
!

interface ethernet 2/1/12
inline power

!

Typical switch:

UNIT 1: compiled on Jun 17 2010 at 18:20:53 labeled as FCXS07100a
HW: Stackable FCX648S-HPOE

Thanks,

John

  • Getting Started with Wireless
Everyone's tags (3)
1 REPLY
Cisco Employee

Re: Brocade FCX PoE with Cisco LAP

Hi John,

Unfortunetally, I will not be able to help you from the switch side. Maybe someone else reading the thread will do; but I wanted to tell you that 11n Access Points have special POE requirements to function as expected.

Check this http://www.cisco.com/en/US/prod/switches/epoe.html if you haven't seen it yet.

Hope this help you

Have a good day

Serge

1283
Views
0
Helpful
1
Replies
This widget could not be displayed.