cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
315
Views
0
Helpful
1
Replies

Calibration Model under WCS

benkwan99
Level 1
Level 1

I received an error message when performing Calibration model to add data points in WCS.

MAC is not detected as a client but found on floor.

Upon reading over the RF calibration, it was noted that Cisco recommends using the Cisco Aironet 802.11 a/b/g Wireless cardbus Adapter Client (AIR-CB21AG) with recent drivers and firmware (CCX version 2 or better) as a calibration data collection client. Versions of CCX earlier than version 2 are not ideal for calibration usage.

Does that mean, I must use a CCXv2 WiFi card to perform the RF calibration?

1 Reply 1

dennischolmes
Level 7
Level 7

It means that the system works better with CCXv2 and later clients when performing a calibration. I used Cisco Card, Intel internal, RFID Tag, and Proxim Card. This assures a good overall calibration. I try to calibrate for multiple devices because the methodology of location services is RF Fingerprinting based on received RSSI values and those can differ between clients.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: