Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Caller id on CME and PRI access

Hello,

I have configured a Cisco call manager express 4.3 on a Cisco 2821 with a VWIC2-1MFT-T1/E1. I have 10 grouped lines from my operator.

The problem is that when someone calls from the outside it appears "from unknown number". I would like to enable the caller id but the command "caller-id enable" dos not exist on the configuration mode of the voice-port 0/2/0:15 (voice port for the VWIC2-1MFT-T1/E1).

Can you help me please to enable the caller id.

Thank you.

2 REPLIES
Silver

Re: Caller id on CME and PRI access

To allow the sending or receiving of caller-ID information, use the caller-id enable command in voice-port configuration mode at the sending foreign exchange station (FXS) voice port or the receiving foreign exchange office (FXO) voice port. To disable the sending and receiving of caller-ID information, use the no form of this command.

caller-id enable [type {1 | 2}]

no caller-id enable [type {1 | 2}]

where type indicates (Optional) Indicates that the following keyword is a caller-ID type.

1-Type I only. Type I transmits the signal when the receiving phone is on hook.

2-Type II only. Type II transmits the signal when the receiving phone is off hook, for instance to display the caller ID of an incoming call when the receiving phone is busy (call-waiting caller ID).

I hope it may helpful to you

New Member

Re: Caller id on CME and PRI access

Thank you for replying,

but in fact my problem is not on the FXO port but in the PRI port.

Thanks

531
Views
0
Helpful
2
Replies