Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

can AIR-CAP1602i-x-k9 be converted to stand alone??

can air-cap1602i-x-k9 be converted to stand alone??

3 REPLIES
New Member

Re: can AIR-CAP1602i-x-k9 be converted to stand alone??

Yes , you can convert the AP to stanadlone  by pushig the below image  into the AP

http://software.cisco.com/download/release.html?mdfid=284366503&flowid=37523&softwareid=284180979&release=15.2.4-JB3a&relind=AVAILABLE&rellifecycle=ED&reltype=latest

You can use the below method to convert the same

Using a TFTP Server to Return to a Previous Release

Follow these steps to revert from LWAPP mode to autonomous mode by loading a Cisco IOS release

using a TFTP server: This method is for local conversion.

Step 1 The PC on which your TFTP server software runs must be configured with a static IP address in the range

of 10.0.0.2 to 10.0.0.30.

Step 2 Make sure that the PC contains the access point image file (such as c1200-k9w7-tar.122-15.JA.tar for a

1200 series access point) in the TFTP server folder and that the TFTP server is activated.

Step 3 Rename the access point image file in the TFTP server folder to c1200-k9w7-tar.default for a 1200

series access point.

Step 4 Connect the PC to the access point using a Category 5 or better Ethernet cable.

Step 5 Disconnect power from the access point.

Step 6 Press and hold the MODE button while you reconnect power to the access point.

Step 7 Hold the MODE button until the status LED turns red (approximately 20 to 30 seconds), and release the

MODE button.

Step 8 Wait until the access point reboots as indicated by all LEDs turning green followed by the Status LED

blinking green.

Thanks..

VIP Purple

can AIR-CAP1602i-x-k9 be converted to stand alone??

HI,

Yes you can.

  • k9w7 – autonomous IOS----> You need this image
  • k9w8 – full lightweight IOS (this is what is bundled in the WLC .aes image, and is factory installed on “mesh” APs)

Here is the procedure:

https://supportforums.cisco.com/docs/DOC-15126

http://mrncciew.com/2012/10/20/lightweight-to-autonomous-conversion/

https://supportforums.cisco.com/docs/DOC-15126

Hope it helps.

Regards

Dont forget to rate helpful posts

Cisco Employee

can AIR-CAP1602i-x-k9 be converted to stand alone??

Yes you can convert lightweight CAPWAP 1602 to autonomous standalone AP. Please refer the link below.1602.png

http://www.cisco.com/en/US/docs/wireless/access_point/ios/release/notes/rn_aap_OL30935_01.html#wp381669

1601
Views
10
Helpful
3
Replies