I just started a home CCNA lab and I've begun with an 1841. So I could toy around with wireless, I bought an access point WIC, the HWIC-AP-AG-B. I've configured one SSID, 1841_WLAN, with a WPA2-PSK security code "password" and both dot11radio interfaces, 0/1/0 and 0/1/1, have AES and TKIP ciphered encryption. As for IP addresses, I have a DHCP pool, also named 1841_WLAN, providing dynamic addresses with a default gateway address set as the IP of the dot11radio0/1/0 interface, 172.16.1.62/27.
When I connect my laptop to the SSID, it is given a dynamic IP address with no problems; the first one in the range as expected. However, when I try to connect my iPhone or iPad, it gives them link-local 169.254.x.x addresses.
I've done a lot of research and I can't find the solution to this. I did learn that Apple devices aren't friendly with WEP but I'm using WPA2 so that shouldn't affect me. If anyone knows a possible solution to this, please let me know. I can provide any snippets of my sh running config output upon request so let me know if it would help. I'm still a beginner...
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...