First time configuring Cisco AP. I have a 1130AG. I configured 2 VLANs (according to Doc ID 69773) and setup IP address on bvi1 port. I can get on a web portal using a cross-over cable connecting a laptop to the AP. However, when I configure a trunk port on the switch, add the 2 VLANS the VTP server and connect the AP to it, I can't connect to the AP. Yet, 'sh cdp nei' displays that the AP is connected.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...