Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Can't see access points

I have 1602i access points with a 2500 controller and an SGE2000 switch. I can get the controller connected and see it but when I plug the access points into the switch I do not even get a link light. I am using PoE injectors. I can connect and get a link light on any other switch including both PoE and non-Poe switches both Dlink and HP. The SGE2000 is pretty much a basic setup, 1 vlan, all ports are set to access.

Any help appreciated

30
Views
0
Helpful
0
Replies