Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cannot Access WLC 2504 GUI when connected through WIFI

Hi,

I have Cisco WLC 2504 whose management ip address is 192.168.1.100 and port 1, when I am connecting through port 1 directly I can access WLC GUI but when I am connecting this port of WLC to switch (with just ip address in vlan 1 192.168.1.123) and AP (192.168.1.2XX) and try to access the WLC GUI the page is not displaying although I can ping the controller.

version of Wireless LAN Controller Software-7.6.120.0(ED)

Thanks.

 

  • Getting Started with Wireless
1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Hi,If you want to access wlc

Hi,

If you want to access wlc via wireless then Please use these commands:

Via GUI:

Management > Mgmt Via Wireless and enable this check box and apply.

Via CLI:

config network mgmt-via-wireless enable.

 

Regards

Dont forget to rate helpful posts

5 REPLIES
New Member

HiWhen a PC is connected to

Hi

When a PC is connected to the switch, you can you ping 192.168.1.100?

If you are connected via Wi-Fi, you will need to enable Management over wireless, otherwise you cannot manage the controller. 

http://www.cisco.com/c/en/us/td/docs/wireless/controller/7-2/configuration/guide/cg/cg_security_sol.html#wp1880985

If still not working, please provide the switch configuration in an attachment and show interface summary from the controller.

Best Regards. 

Christian

 

 

Christian J. Estes, cwne #85, cciew #42615

Just to complete this

Just to complete this discussion, access is not possible if you are connected to an OEAP.

 

VIP Purple

Hi,If you want to access wlc

Hi,

If you want to access wlc via wireless then Please use these commands:

Via GUI:

Management > Mgmt Via Wireless and enable this check box and apply.

Via CLI:

config network mgmt-via-wireless enable.

 

Regards

Dont forget to rate helpful posts

New Member

Thanks all,After enabling

Thanks all,

After enabling Management via Wireless it started working.

 

Thanks again...!

 

New Member

Please don't forget to rate

Please don't forget to rate useful posts.

Christian J. Estes, cwne #85, cciew #42615
483
Views
14
Helpful
5
Replies