Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cant get radio to enable

Looking at the Radio status tab on a Aironet 1200 ap running latest firmware and it shows the  software status as disabled and the hardware status as down, but I have  the radio enabled.  Any ideas?

Thanks,

Pedro

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Cant get radio to enable

Pedro,

     You don't mention if your AP is autonomous or Lightweight, but I am assuming by your description it is an autonomous access point, have you completed the configuration on the AP (ex: IP Address, SSID's, Encryption, etc?) I know the latest firmware will not bring the radio on-line until those conditions are met.. Also is you want to use it as a standard AP make sure the Station Role is Root (Root Access Point,Root Access Point Radio Island, Root Access Point Radio shutdown).

Hope this helps... Please rate useful Posts.

Thanks,

Kayle

3 REPLIES

Re: Cant get radio to enable

Do you mean the radios are disabled and the hardware is up? --> you use a power-injector?

Re: Cant get radio to enable

Pedro,

     You don't mention if your AP is autonomous or Lightweight, but I am assuming by your description it is an autonomous access point, have you completed the configuration on the AP (ex: IP Address, SSID's, Encryption, etc?) I know the latest firmware will not bring the radio on-line until those conditions are met.. Also is you want to use it as a standard AP make sure the Station Role is Root (Root Access Point,Root Access Point Radio Island, Root Access Point Radio shutdown).

Hope this helps... Please rate useful Posts.

Thanks,

Kayle

New Member

Re: Cant get radio to enable

That was it.... Thanks a million!

312
Views
0
Helpful
3
Replies
CreatePlease login to create content