I am trouble shooting an AP someone installed. I found that when I tried pinging the device from a different subnet the pings failed. I connected to the switch the AP plugged into and was able to telnet to the AP using the source network. The default gateway was wrong and I corrected it, but even after correcting the default gateway I still could not ping it. Other devices on the same subnet as the AP, like the switch can be accessed remotely with no problem.
interface GigabitEthernet0 no ip address no ip route-cache duplex auto speed auto no keepalive ! interface GigabitEthernet0.1 encapsulation dot1Q 1 native no ip route-cache bridge-group 1 bridge-group 1 spanning-disabled no bridge-group 1 source-learning
interface BVI1 ip address 10.100.5.6 255.255.255.0 ! ip default-gateway 10.100.5.1
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...