Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CAP2602

Hi ,

I have ordered Cisco CAP2602i access points , the software ordered was MESH ,is there any way we can change the software to RECOVERY after we received the WAP.

Thanks in advance.

Regards ,

mahesh

4 REPLIES
VIP Purple

Re: CAP2602

You can add the ethernet MAC address of the AP on to WLC mac filter (secuirty -> MAC filter) & then you can register this AP as a Mesh AP. Then you can change the mode to Local.

Otherwise you can upload the recovery image onto the AP via TFTP. Pls see the below for more detail

http://mrncciew.com/2013/12/13/ap-conversion-using-mode-button/

HTH

Rasika

*** Pls rate all useful responses ****

Community Member

Re: CAP2602

Thanks Rasika, Does Local mode here mean automonous ? or is it the recovery image.

VIP Purple

Re: CAP2602

No, Local mode mean the standard Light Weigth Access point mode (Not Autonomous)

HTH

Rasika

**** Pls rate all useful responses ****

Cisco Employee

CAP2602

Try this,

debug capwap console cli

test mesh mode local

Thanks,

Sahil

323
Views
0
Helpful
4
Replies
CreatePlease to create content