Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Cisco Employee

Capwap 1142 to Autonomous

I have an 1142 running capwap c1140-k9w8-tar.124-23c.JA4  that I am wanting to convert to an Autonomous AP.

However, the AP does not seem to have an archive exec  command to tftp downoad an new IOS.

Is there another procedure that should be used?

Thanks

John

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Capwap 1142 to Autonomous

Did you go into the config mode?

AP#en

AP#config t

AP#debug capwap console cli

-Scott
*** Please rate helpful posts ***
7 REPLIES
Cisco Employee

Capwap 1142 to Autonomous

Please use the below link..

https://supportforums.cisco.com/docs/DOC-14960

Regards

Surendra

Cisco Employee

Capwap 1142 to Autonomous

Thanks,

The issue that I seem to be having is that when in enable mode, I do not see an archive command available in the exec.

as is suggested from the doc above.

is it possible that 12-4-23c.JA4 would have a different command structure?

THx,

John

Hall of Fame Super Silver

Capwap 1142 to Autonomous

Did you go into the config mode?

AP#en

AP#config t

AP#debug capwap console cli

-Scott
*** Please rate helpful posts ***
Cisco Employee

Capwap 1142 to Autonomous

Interestingly,

The AP does not have config t as a command. ( yes, I am in enable mode)

I can issue a debug capwap from the exec, but console is not an option.

Hall of Fame Super Silver

Re: Capwap 1142 to Autonomous

Wait... Do the debug capwap console CLI first then try the archive command

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
New Member

Re: Capwap 1142 to Autonomous

Thank you for the hint!  Doing debug capwap console CLI first did the trick.

Hall of Fame Super Silver

Re: Capwap 1142 to Autonomous

Glad you got it working!

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
1164
Views
0
Helpful
7
Replies
CreatePlease to create content