Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Catalyst 3750G and WLC 440x - Port Channel - Configuration - Best Pactice

What is the best practice to use when configuring port channel between Catalystr 3750G switch stack and WLC 4402 / 4404 Wireless Lan Controllers:

a) Negotiate to LACP

b) Negotiate to PAgP

or

c) Hard-code to Port Channel without any negotiation.

Any pointers to any useful links - much appreciated and configuration example as well.

1 REPLY
Hall of Fame Super Silver

Re: Catalyst 3750G and WLC 440x - Port Channel - Configuration -

Answer is 'C'... channel-mode on

Configuring Neighbor Devices to Support LAG

The controller's neighbor devices must also be properly configured to support LAG.

•Each neighbor port to which the controller is connected should be configured as follows:

interface GigabitEthernet

switchport

channel-group mode on

no shutdown

•The port channel on the neighbor switch should be configured as follows:

interface port-channel

switchport

switchport trunk encapsulation dot1q

switchport trunk native vlan

switchport trunk allowed vlan

switchport mode trunk

no shutdown

Here is a link that explains it. Hope this answers your question:

http://www.cisco.com/en/US/docs/wireless/controller/4.2/configuration/guide/c42mint.html#wp1116136

Here is a Best Practice doc:

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_tech_note09186a0080810880.shtml

-Scott
*** Please rate helpful posts ***
891
Views
5
Helpful
1
Replies
CreatePlease to create content