Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Change default password on LAP?

I have several new 2602e access points configured on two 4408 WLCs. All went surprisiongly well with the installation and configuration. However, I want to change the default user and password, but I'm not sure where to do this from. There doesn't appear to be a configure command in enable mode on the APs and I can't find where the user accounts might be controlled from the controller.

Anyone know the answer?

Thanks!

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Change default password on LAP?

Here is where you would change it.  You would also have to enable ssh or telnet on each AP

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***
5 REPLIES
Hall of Fame Super Silver

Change default password on LAP?

Here is where you would change it.  You would also have to enable ssh or telnet on each AP

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***

Change default password on LAP?

Hello Scott.

One questions when you set up an username & password the changes are apply to all AP's ?

Community Member

Change default password on LAP?

Worked like a charm. Thanks for the prompt reply. I must have passed over that page a dozen times. The light just never went on, I guess

Hall of Fame Super Silver

Re: Change default password on LAP?

Yeah or else its the default Cisco/Cisco.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***

Change default password on LAP?

Hello Sali,

As per your query i can suggest you the following solution-

To change the default user and password. It can be done under wireless tab then go to global configuration.

Hope this will help you.

198
Views
0
Helpful
5
Replies
CreatePlease to create content