Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Changing LWAPP Transport from Layer 2 to Layer 3

I'm looking to change our LWAPP Transport from Layer 2 to Layer 3. Is is as easy as just changing the LWAPP Transport Mode setting on our controllers (4402)saving and rebooting? Will I need to reboot the access points as well? (OTAP is enabled)

Thanks.

2 REPLIES
Hall of Fame Super Red

Re: Changing LWAPP Transport from Layer 2 to Layer 3

Hi Alan,

You shouldn't need to do anything to the AP's. Here is a little clip;

In order to change the LWAPP Transport Mode using the GUI, go to the WLC page and locate the second selection in the main field which is LWAPP Transport Mode. Change this to Layer 3 and reboot the controller.

From this doc;

http://www.cisco.com/en/US/products/ps6366/products_qanda_item09186a008064a991.shtml

Hope this helps!

Rob

Cisco Employee

Re: Changing LWAPP Transport from Layer 2 to Layer 3

Hi Alan,

In addition to Rob's post I will recommend you to make sure you have DHCP server available for your APs to get an ip address so that they can join controller.

HTH

Ankur

362
Views
0
Helpful
2
Replies