Is there any way to use Cisco 1010 Light Weigh Access Point as a stand alone Cisco Aironet device, without having a WLC.
We have few 1010 LWAP, but no WLC. These AP's are based on Power over Ethernet feature. We connect these AP's to a POE based switch, they are up. By enabling DHCP on the switch we are able to get an IP address for the same AP,also we can easily ping the IP address. But when we try to open the HTTP based management console for the AP, at that time it didn't work. Do we need to have a WLC for the configuration and management, or is there any other way out for it.
You have to keep in mind that the 1010 is a "true" Lightweight AP. This means there is no IOS on the AP for it to be able to operate in a "standalone" or Autonomous manner. So, on Lightweight AP's there is no http based management interface. All config settings must be done via a WLC :(
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...