Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.
I have gotten into the AP
Used Express Setup to put in new Address, when clicking ok to save the browser can no longer connect.
I used a crossover cable and straight through but with the same outcome
Try HTTP/HTTPS to the AP using the new IP address.
if by that you mean put the new IP into a browser and try to connect I tried that with no success.
what is wrong here, I have 3 of these units and they are all doing the same thing do they need to be re-imaged to use individually and if so where can I find the file