03-27-2012 06:40 PM - edited 07-03-2021 09:53 PM
Hi Team,
I am trying to provision three 1142 AP's so they broadcast multiple SSIDs. I have set the following commands, but I am not able to get more than one SSID to broadcast. As you can see I added the "guest-mode" command to one of the SSIDs which took it without problems. That other SSID does not accept the command. What am I missing? Any help is greatly appreciated.
dot11 ssid Test
vlan 2
authentication open
authentication key-management wpa version 2
guest-mode
mbssid guest-mode
wpa-psk ascii 7 052C3323076D673B48
!
dot11 ssid Test1
vlan 3
authentication open
authentication key-management wpa version 2
mbssid guest-mode
wpa-psk ascii 7 075B07141E5D38263140
!
IOS version is Version 12.4(21a)JA1
Thank you,
Solved! Go to Solution.
03-27-2012 06:53 PM
MBSSID GUEST-MODE is enough.. please remove the command GUEST-MODE under the SSID Test.. this should work..
03-27-2012 06:53 PM
MBSSID GUEST-MODE is enough.. please remove the command GUEST-MODE under the SSID Test.. this should work..
03-27-2012 07:09 PM
You also need the global command dot11 mbssid and then über the radio interface(s) mbssid
Steve
Sent from Cisco Technical Support iPhone App
03-27-2012 07:34 PM
Thank you everyone. I will test tomorrow morning and will update this post.
Thanks again for your help,
Gerson
04-16-2012 02:53 PM
Thanks again. The command above resolved the problem I was having broadcasting SSID's
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide