You can always start with the config guides or the config exmaples. These will be sure to fill your days and nights with fun learning. You can find these under the config section ....
"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
You need to look at the link I sent. It's basic for most AP models. There are steps on basic configurations to security, etc. the router and switch will be on a different section in CCO. I just don't think you will find any good lab guides out there on autonomous AP unless someone here has taken a class back in the days and might of save the manual or lab guide.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...