cisco 2504, clients are getting management DCHP adress
Having problem rerouting right DHCP threw our external DHCP:s. Got the radius and connection to work fine but my AP:s just gives the client computers DHCP adresses from the management inferface.
primary DHCP 10.110.1.200
Made av Dynamic VLAN that is connectet to my WLAN
AP uses static (works ofcourse if i also use a dynamic ip) ip and is connected in 10.110.27/24 network
Controller DHCP proxy off
The network works fine with theese setings but the clients gets a ip of 10.110.1.50 from our extrenal DHCP the idea is that it should get an 10.110.27.x adress.
Cisco 2504 doesn´t use ap-managemet interfaces. So what am i missing, and how do you get a user made interface to give the right ip to the clients. Or is it even possible whitout the internal DHCP proxy?
Re: cisco 2504, clients are getting management DCHP adress
If you don't have dhcp proxy, you need to make sure you have an ip helper on clan 27 that points to your dhcp server. If you enable dhcp proxy and you still can't receive a proper IP address then its a network issue and you might not be trunking vlan 27 to the WLC.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...