Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 2504 Management Via Wireless

I have a 2504 connected via a 2960S switch to an ASA5505.

Wireless is working well - wireless clients get their IP addresses from the 2504 and wired clients from the ASA (different ranges from the same subnet).

One issue though is I cannot access the web interface of the 2504 when connected to wireless, only wired.  Everything else is accessible on wireless and I can ping the management address of the 2504 but the page fails to load in a browser.

I've had a look for an obvious setting but can't see one - am I missing something.

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

HI,First you must enable the

HI,

First you must enable the management over wireless:

Via GUI:

Management Mgmt Via Wireless page and check the Enable Controller Management to be accessible from Wireless Clients check box.

Via CLI:

config network mgmt-via-wireless enable

 

Regards

Dont forget to rate helpful posts

2 REPLIES
VIP Purple

HI,First you must enable the

HI,

First you must enable the management over wireless:

Via GUI:

Management Mgmt Via Wireless page and check the Enable Controller Management to be accessible from Wireless Clients check box.

Via CLI:

config network mgmt-via-wireless enable

 

Regards

Dont forget to rate helpful posts

New Member

Thanks - and sorry!  Really

Thanks - and sorry!  Really not sure how I managed to miss that...

48
Views
0
Helpful
2
Replies