I am looking to install some 2602I-Z-K9 access points (i haven't bought them yet) we currently have one 5508 WLC running on 7.2.x as I understand it from the 7.5.x release notes you need to be on 7.5.x to support the 3602I-Z-K9 AP's (new -Z regulatory domain for Australia). But I cannot seem to find any information on weather or not i need to be on at least 7.5.x to support the 2602I-Z-K9 access points as well.
Any assistance in this matter will be much appreciated.
Here's the deal ... Starting from the 702, 1600, 2600, 3700 and the RM3000AC (802.11ac radio module for 3600) and anything forward, you'll need the "-Z" regulatory domains.
Now notice that the 3600 is still "-N" but the RM3000AC isn't. I believe there is a little bit of "leeway". If you purchased a 2600 "-N" by mistake it will work in the same Regulatory Domain of "-Z". I know because I purchased ten (10) eco-boxes. "-Z" Regulatory Domain is/can support "-N" Regulatory Domain.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...