04-28-2014 11:07 PM - edited 07-05-2021 12:45 AM
Dear Team,
need help to configure DHCP on cisco switch can share the conf temp for DHCP server config
one more issue i have same model switch with lanlite ios i want to configure port with permanent ip on switch ports that is possble or not if possible can any one help me how to configure.
switch port mapping configuration temp can any one share pls i am doing this in fresh swith there is no any conf ont that switch
Solved! Go to Solution.
04-29-2014 01:08 AM
Hi kamal
2960 is a layer 2 switch there fore you canot configure ip address on this switch.you need to buy any layer 3 switch to configure this.
04-29-2014 03:54 AM
just regular vlan setting.
04-29-2014 01:08 AM
Hi kamal
2960 is a layer 2 switch there fore you canot configure ip address on this switch.you need to buy any layer 3 switch to configure this.
04-29-2014 02:02 AM
Dear kaaftab,
i dont want to configure ip on l2 switch but i want to know port mapping is possible or not pls hlp
04-29-2014 02:20 AM
Hi kamal
Can you elaborate what exactly you want to configure as only L3 config for ip's is mgt ip that you can configure.
04-29-2014 02:56 AM
Dear Kaaftab,
actually client reqiurement is if i connect multiple laptop on same switch port always i get the same ip from dhcp is there any possibility on 2960 for same ?
bcoz i dont have any idea,
so can u help
because i have done the below conf
ip dhcp pool vlan2
network 10.123.123.0 255.255.255.0
interface FastEthernet0/38
switchport access vlan 2
ip dhcp server use subscriber-id client-id
ip dhcp use subscriber-id client-id
ip dhcp subscriber-id interface-name
ip dhcp pool vlan2
network 10.123.123.0 255.255.255.0
address 10.123.123.115 client-id "fa0/38" ascii
its not working
pls guide how to conf port mapping
04-29-2014 03:44 AM
try this syntax::
ip dhcp pool vlanx
host 192.168.0.10 255.255.255.255
client-identifier 0112.3456.7890.ab (host Mac)
lease infinite
Note:
Make sure your static ip is not in the DHCP pool.
04-29-2014 03:44 AM
Thanks a lot Kaaftab
i will to do same conf on my switch and on switch interface any conf is required.
04-29-2014 03:54 AM
just regular vlan setting.
04-29-2014 03:57 AM
thanks Kaaftab
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: