Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cisco 4400 series wireless controller and 1242 WAP

Can anyone tell me if there are any issues with using Cisco 1242 access points along with a 4400 series wireless controller.  Does either device need a specific firmware?

 

Thanks

Chris

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

No issues, it will work.If

No issues, it will work.

If possible get your 4400 upgraded to 7.0.x code as it is the last supported code for 4400. APs will automatically get image from WLC once register

Refer this table for any compatibility information

http://www.cisco.com/c/en/us/td/docs/wireless/compatibility/matrix/compatibility-matrix.html

 

HTH

Rasika

**** Pls rate all useful responses ****

3 REPLIES
VIP Purple

No issues, it will work.If

No issues, it will work.

If possible get your 4400 upgraded to 7.0.x code as it is the last supported code for 4400. APs will automatically get image from WLC once register

Refer this table for any compatibility information

http://www.cisco.com/c/en/us/td/docs/wireless/compatibility/matrix/compatibility-matrix.html

 

HTH

Rasika

**** Pls rate all useful responses ****

New Member

Thanks for the help Chris

Thanks for the help

 

Chris

VIP Purple

Hi Chris,Pls mark the thread

Hi Chris,

Pls mark the thread as answered if you get the info you looking for

Rasika

 

89
Views
0
Helpful
3
Replies
CreatePlease to create content