Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 4404 WLC

I want to etherchannel my Cisco 4404 to my Catalyst 6513. I create the etherchannel on my 6513, but was wondering how I create my etherchannel on my Cisco 4404? The commands are not the same as my Catalyst 6513. Any guidance would be appreciated.

  • Getting Started with Wireless
2 REPLIES
Hall of Fame Super Silver

Re: Cisco 4404 WLC

You need to go to the General tab on your 4404 GUI and set LAG to enable. Also make sure you configure your etherchannel to channel-mode on and that etherchannel load balance is configured to scr-dst-ip.

Thanks, Scott *****Help out other by using the rating system and marking answered questions as "Answered"*****
New Member

Re: Cisco 4404 WLC

Here is the link to the config guide on cisco site that explains the procedure

http://www.cisco.com/en/US/docs/wireless/controller/5.0/configuration/guide/c5mint.html#wp1113877

301
Views
0
Helpful
2
Replies
This widget could not be displayed.