Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 877W Wlan no more working.

Hi@ll,

im new to Cisco and his IOS. I config the 877W with SDM and CLI and have build a running config. But my problem was that wlan clients can acces the wan but not the lan. So try to change over webinterface that wlan are in vlan1.

i restart and have no more wlan and in the config i have now the subinterface Dot11Radio0.1 ? How can i Delete this? I try it from SDM and Reboot but is everytime in the config again.

My config looks like this

interface Dot11Radio0

description WLAN

no ip address

!

encryption mode ciphers tkip

speed basic-1.0 2.0 5.5 6.0 9.0 11.0 12.0 18.0 24.0 36.0 48.0 54.0

channel 2462

station-role root

no cdp enable

bridge-group 1

bridge-group 1 subscriber-loop-control

bridge-group 1 spanning-disabled

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

!

interface Dot11Radio0.1

encapsulation dot1Q 1 native

shutdown

no cdp enable

bridge-group 1

bridge-group 1 subscriber-loop-control

bridge-group 1 spanning-disabled

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

!

3 REPLIES
New Member

Re: Cisco 877W Wlan no more working.

hi@ll,

no body have a solution? How i can remove the subinterface Dot11Radio0.1 without that it worked.

Thanks.

Anonymous
N/A

Re: Cisco 877W Wlan no more working.

Coudl you verify the SSID details, also Are you using WPA ?

New Member

Re: Cisco 877W Wlan no more working.

Hi rroas45,

thanks for your reply.

My ssid details are working before of the change and yes im using wpa. I make the change because i can not acces to my lan clients from wlan. I make it wrong and i can not make return config because im new to cisco and his ios. Here are my ssid details.

dot11 ssid XXXXXXX

vlan 1

authentication open

authentication key-management wpa

guest-mode

wpa-psk ascii XXXXXXXXXXXXXXXXXXXXXX

!

no ip source-route

ip cef

!

Regards Kemal

189
Views
0
Helpful
3
Replies