Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco Access Point Configuration to support 802.11b & 802.11g protocol

How do i Configure access point to support both 802.11b & 802.11g clients on a Cisco 1121G series access point(AIR-AP1121G-A-K9)

Regards

Hitesh

1 REPLY
Hall of Fame Super Red

Re: Cisco Access Point Configuration to support 802.11b & 802.11

Hi Hitesh,

Check out this excerpt from the 1121g AP Installation guide section on enabling the 802.11b and 802.11g radios.

In Cisco IOS Release 12.3(4)JA and later, the access point radios are disabled by default, and there is no default SSID. You must create an SSID and enable the radios before the access point will allow wireless associations from other devices. These changes to the default configuration improve the security of newly installed access points. Refer to the "Configuring Basic Security Settings" section for instructions on configuring the SSID.

In Cisco IOS Release 12.3(2)JA or earlier, the access point radio is enabled by default, and the default SSID is tsunami.

To enable the radio interfaces, follow these instructions:

--------------------------------------------------------------------------------

Step 1 Use your web-browser to access your access point.

Step 2 When the Summary Status page displays, click Network Interfaces > Radio0-802.11B or Radio0-802.11G and the radio status page displays.

Step 3 Click Settings and the radio settings page displays

Step 4 Click Enable in the Enable Radio field.

Step 5 Click Apply.

Here is a link to the actual document:

http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_installation_guide_chapter09186a00804d2b73.html

Hope this helps!

Rob

Please remember to rate helpful posts....

402
Views
0
Helpful
1
Replies