Cisco Air-AP1131G-A-K9 won't get any configuration!
I got an Air-AP1131G-A-K9 and somehow it's not getting most of the configuration on the web interface! Radio0 is off, wireless network has not been configured, and I'm changing the settings and save,... then nothing is changing! It's like I'm on read only mode, if there's any.
The Home screen on web interface doesn't contain any interface, even the Ethernet that I'm connected to it, and it's enabled.
Express Setup and Express Security pages won't save any configuration. The pages are staying the same.
Can't Enable Radio0 on Network Interfaces. On radio buttons of the Setting page the Enable is still selected but the interface is Disable/Down
The only tinhg that I was able to change and save and it's working, was adding a new Admin User.
I tried web factory reset, hardware reset, CLI erase startup, with no luck!
(Background: I got this in my work place warehouseand it's look like brand new. Everything is in the box. At the first use I wasn't able to login to the device using Cisco, Cisco and I think the Radio light was on "not sure". I reset the device using the Mode button, and now this is my issue)
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...