Cisco AIR CAP3502I E K9--- standalone Config

[muzecisco]

Hello good people. I have recently bought Cisco AIR CAP3502I E K9 but i am seeing that it can only work with WLAN controller. How can I make it work as a stand alone.

Your help will be appreciated.

[muzecisco]

Any good links on how i can start configuring it as standalone WAP

[Scott Fella]

Take a look at this

https://supportforums.cisco.com/docs/DOC-20537

Sent from my iPhone

[Scott Fella]

You can use the 1260 autonomous code if you want. Just remember, this isn't supported by Cisco but it will work.

Sent from my iPhone

[Surendra BG]

U can convert but not supported by TAC!!

use the below link..

https://supportforums.cisco.com/docs/DOC-14960

Please dont forget to rate the usefull posts!!

Regards

Surendra

[muzecisco]

Scott whats the autonomous code 1260 for and how is it used. I have never confugured a cisco wirelsess AP

[muzecisco]

This information is so helpful. Last part is where can i get

cisco IOS for 1260 ap3g1-k9w7-tar.124-25d.JA1

Don have smartnet account

[Scott Fella]

Send me an email you on that.

[muzecisco]

muzendaf@gmail.com

[muzecisco]

Team confirm that after this conversion to standalone it can pass traffic. I have read some text which say it cannot pass traffic.

[Scott Fella]

Where did you read that? You should have no issue since the 3502 radios are the same as the 1260. You just won't have the full feature of the 3502.

Sent from Cisco Technical Support iPhone App

[muzecisco]

Thanks Fella.

Any document showing how to finish off the configs after the IOS chnage. The howto docs for 1260/3502 for stand alone most i am seeing are for controller based. Have never setup a cisco WAP but i understanda and am into cisco

[Scott Fella]

You can reference this guide for the 1140

http://www.cisco.com/en/US/docs/wireless/access_point/1140/autonomous/getting_started/guide/ap1140aut_getstart.html

http://www.cisco.com/en/US/docs/wireless/access_point/12.3_7_JA/configuration/guide/s37ssid.html

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008055c39a.shtml

Sent from Cisco Technical Support iPhone App

[Scott Fella]

Here is a link from George's blog page

http://www.my80211.com/home/2011/11/18/autonomous-ios-support-for-3500-and-3600-series-access-point.html

Sent from Cisco Technical Support iPhone App

[muzecisco]

I am still having troubles with this issue.

Scott kindly resend the image again as it should be uploaded.

Another challenges is setting the ip address go g0 interface. Even though i do that manually dhcp continues to discard the manual n gets smthing from my dhcp since it will continously look for WController.

How do i sort this out.

I have also failed to access the GUI thru the private ip add