cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3613
Views
45
Helpful
19
Replies

CIsco AIR LAP1131AG E K9 Status LED = Yellow; Ethernet LED = Off; Radio LED = blinking Red, what is this? it isn't in the manual

bkeskin01
Level 1
Level 1

CIsco AIR LAP1131AG E K9 Status LED = Yellow; Ethernet LED = Off; Radio LED = blinking Red in a pattern, red off then red red, Our AP isn't working it won't show up on our Cisco WLC 2125 anymore and this is the LED indicators, I've checked in the manual and this combination of LEDs do not exists??

19 Replies 19

Did you used this command before starting :

debug lwapp console cli

Did you converted this AP from autonomous mode to LAP?

If yes then i will suggest to change the mode to autonomous(k9w7) and then again upload a new image(k9w8).

here is the procedure.

http://rscciew.wordpress.com/2014/05/07/access-point-conversion-lap-to-aap-and-vice-versa/

 

***if still have problem then come on teamviewer(if you want then only )

 

Regards

I think there is an issue with Cisco website, when I download the IOS image for the AP it should be 5mb but says 0bytes :/

No cisco web is working perfectly.

do you have a valid CCO id with smarnet contract ?? then only you can download new IOS for AP:

Autonomous AP image:

http://software.cisco.com/download/release.html?mdfid=279537722&flowid=6775&softwareid=284180979&release=12.4.25d-JA2&relind=AVAILABLE&rellifecycle=ED&reltype=latest

 

LAP AP image:

http://software.cisco.com/download/release.html?mdfid=279537722&flowid=6775&softwareid=280775090&release=12.4.25e-JAP&relind=AVAILABLE&rellifecycle=ED&reltype=latest

Regards

Ok everything is setup, image and also TFTP server however I don;t seem to be able to ping the server or the AP. They are both on the same subnet with IP server 10.0.0.5 255.0.0.0 and AP 10.0.0.1 255.0.0.0 But they can't connect to eachother?

 

reload requested by lwapp client, reload reason could not fall back to DHCP, what does this mean?

Means AP lost the IP address from its interface.

And make like this:

AP: 10.0.0.2 255.255.255.0

TFTP: 10.0.0.5 255.255.255.0

 

Regards

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card