Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CISCO AIR-LAP1252AG-A-K9 Autonomous DHCP config?

N00b questions:

  1. Can the 1252AG provide server DHCP in the Autonomous IOS configuration ? ( The WAP is connected to a Linksys router that is providing a NAT address via DHCP to the ethernet interface)
  2. What is the most basic DHCP configuration option ?
  3. I'm assuming the WAP can also pass through the NAT / DHCP from the Linksys router ? What would be the most basic configuration for that?

Thanks,

-Nick

1 REPLY
New Member

Re: CISCO AIR-LAP1252AG-A-K9 Autonomous DHCP config?

https://supportforums.cisco.com/thread/2001254?tstart=0

http://www.cisco.com/en/US/docs/wireless/access_point/12.2_13_JA/configuration/guide/s13adm_ps4570_TSD_Products_Configuration_Guide_Chapter.html#wp1057097

"Configuring the Access Point to Provide DHCP Service

These sections describe how to configure the access point to act as a DHCP server:

•Setting up the DHCP Server

•Monitoring and Maintaining the DHCP Server Access Point
Setting up the DHCP Server

By default, access points are configured to receive IP settings from a DHCP server on your network. You can also configure an access point to act as a DHCP server to assign IP settings to devices on both your wired and wireless LANs."

I'm assuming this also applies to the 1252?

6781
Views
0
Helpful
1
Replies
CreatePlease to create content