Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco Air SAP-2602i not working properly with Linksys WI-FI Range Extender RE2000v2

Hi!

I have problem with right configuration of my Cisco Aironet Acces Point SAP-2602i. So I have Linksys wi-fi range extender RE2000v2 which good working with any touters like TP-link or D-link. It as repeater connect ro wi-fi ssid from router and became transparent for my wireless clinents/ But not with my Cisco AP/

This is my sample of Cisco Aironet Acces Point SAP-2602i configuration:

ap(config)#dot11 ssid CISCO_WIFI
ap(config-ssid)#authentication open
ap(config-ssid)#authentication key-management wpa version 2
ap(config-ssid)#guest-mode
ap(config-ssid)#wpa-psk ascii WIFI_PASSWORD

ap(config)#interface Dot11Radio0
ap(config-if)# encryption mode ciphers aes-ccm
ap(config-if)# encryption mode ciphers tkip
ap(config-if)# ssid CISCO_WIFI
ap(config-if)# no shutdown

And here my network topology:

ROUTER (with DHCP) ---wired connect--> Cisco SAP 2602i ---wireless connect ---> Linksys wi-fi repeater RE2000v2

 

Linksys can get this Wlan, can connect with it. But then any wireless client connetc to this WLAN - repeater show message that no internet and you have trouble with you router. Also any wireless clients can connect to Cisco AP without any problems.

There is problem in configuration of my AP? Why repeater didnt get DHCP from ROUTER?

Please help!

Everyone's tags (1)
2 REPLIES
VIP Purple

Try configuring

Try configuring "infrastructure-ssid" under your SSID & see.

Also remove "encryption mode ciphers tkip" form Radio0 as well

 

HTH

Rasika

**** Pls rate all useful responses ****

New Member

Hi! Thank you for advice!I

Hi! Thank you for advice!

I did next:
ap(config)#dot11 ssid CISCO_WIFI
ap(config-ssid)#authentication open
ap(config-ssid)#authentication key-management wpa version 2
ap(config-ssid)#guest-mode
ap(config-ssid)#wpa-psk ascii WIFI_PASSWORD
ap(config-ssid)#vlan 1
ap(config-ssid)#infrastructure-ssid
ap(config-ssid)#exit
ap(config)#interface Dot11Radio0.1
ap(config-subif)#encapsulation dot1Q 1 native
ap(config-subif)#end

ap#write memory

ap#configure terminal

ap(config)#interface Dot11Radio0
ap(config-if)# encryption vlan1 mode ciphers aes-ccm
ap(config-if)# ssid CISCO_WIFI
ap(config-if)# no shutdown
ap(config-if)# exit

ap#write memory

 

And...It doesn't work as I want..my repeater also connect to AP, but  didn't give DHCP adressing to him wireless clients..

may be something wrong in my configuration? I'm not familiar with Cisco IOS..so help me in details please..

288
Views
0
Helpful
2
Replies
CreatePlease login to create content