Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.
I have a cisco aironet 1100 series wireless access point, by misteke i upgarde ios image to 1200 series. before upgarde i erase flash from 1100 AP.
when i reload the AP all leds lights are solid green, tried to set factory default but no luck. this didnt get any ip address, there is no console port.
how can i access this 1100 AP to rommon mode, so i can breake the sequence and erase the 1200 ios image. need your help.............
- TFTP ip address= 10.0.0.2 - IOS rename = c1100-k9w7-tar.123-8.JEA2.tar -> c1100-k9w7-tar.default - IOS copy = tftp root folder
1100ap "mode" push 40sec
1100ap power off -> on